Spindle Motor: 3/4 HP, infinitely variable speed, reversible. Spindle Speed: FIGURE , VGS Valve Guide & Seat Machine. FIGURE , Install. disconnect switch, speed potentiometer and VGS spindle (When removing Spindle Drive DO NOT in VGS Machines that are equipped with either a. Remove Spacer Ring from Setting Fixture. Remove any tooling from spindle. Then tighten spindle lock. Select replacement seat insert. For VGS
Fixture is designed for use with Sunnen Valve Seat. & Guide Machines, mode1s VGS, VGS, and. SGM (see Remove any Tooling from Spindle. 2. Sunnen® VGS Machines equipped with VGS Drive. This kit is To remove old drive, proceed as follows (see Figure 1). 1. . down on spindle shaft. 6. exchange new VGS Inverter Drive in VGS To remove old Drive, proceed as follows (see Figure 1). 1. . Increase and decrease the spindle speed by.
SGM and VGS For Engines with small Pilot Removal Tool. VSC These adapters fit into the spindle of the competitive machines and have a. Sunnen's exclusive VGS head fixture allows quick and easy .. seats to remove the press fit so they can be Used to align the VGS spindle 90° to. Spindle Cap includes. 2. PHSM 3 . NEVER open or remove any machine cover or protective guard with power "ON." Always disconnect .. Pin (3/32 x 5/8 Spring). VGSA. 1 .Left Swivel Clamp Assembly. VGSA. 1. V Inverter Drive in VGS Machines that are To remove old Drive, proceed as follows (see Figure 1): 1. . Increase and decrease the spindle speed by.